R&S AFGU 1 uHz…20 MHz

AFG and AFGU provide practically all signals that are required in electronics, electroacoustics, vibration measurements,
material testing and control engineering. Modulation modes include AM, FM, PM (pulse), FSK (frequency shift keying) and VCO operation.
FSK and PM can be triggered internally or externally. AM and FM can be produced with the aid of external modulation signals.

Typical applications
? Analog and digital techniques
? All broadband applications such as frequency response/filter measurements
? Acoustic measurements
? Frequency divider and multiplier
(AFGU)
? Waveform regeneration, transformation
? On/off ratio variation, level shift
keying
? Stimulating source in test systems
? Tests on sonar equipment
? Control engineering
? Triggering of pressure, tension and torsion testing machines in material testing
? Triggering of test equipment for vibration testing and operational load simulation
? Ramp and sine2 pulse through variation of symmetry, start/stop phase and DC offset
? Single pulses, pulse trains -internally /externally triggered, adjustable edges
? Linear/logarithmic sweep (phasecontinuous steps)
? AM, FM, VCO, pulse modulation and frequency shift keying

Additional features of AFGU
? Synthesizer-accurate signals
? Arbitrary (ARB) waveforms
? Use of special ARB software
(AWD-K1; page 245) on a PC
? FN and FxN mode
? Arbitrary (ARB) sweep
? Enhanced level range, selectable
source impedance 5/50 Ohm